By . Air Compressor. At Sunday, September 09th 2018, 12:38:15 PM.
Make sure that your air compressor pump is the most appropriate one for your tank. This way you can use your equipment to its fullest and to avoid accidents and injuries while working. It is important that you be able to identify which pump is the best for your nature of work, because there are many types of air compressor pumps available.
Years later, I built a smaller woodworking shop in my home which only required one air sander running at a time. For that shop, I purchased an air compressor half the size and isolated it in a soundproof room in one section of the shop. I ran galvanized pipe under the shop floor to three regulators at three different connection locations. The machine I purchased for that shop as a 5 HP Ingersoll Rand model with an 80 gallon tank. At the 80 PSI required by my Dynabrade sander, the compressor would produce enough air from morning to night. I must say that that compressor was very well built. All I had to do was keep an eye on the oil level in the sight glass. At night, I would turn off the master air valve on the side of the air compressor, leaving the electricity on, to silence the compressor until the next work day.
Compression not only produces heat but squeezes water out of the air which ends up in the tank. Tanks can rust internally over time and if this is not controlled, the rusted air tank can eventually explode causing considerable damage and even death. That is why it is really important to evacuate the tank of water regularly. Most air compressors come equipped with a drain valve at the lowest point of the tank. If you dont want to spray water all over the floor under the unit, you may want to consider piping it from the valve to another place such as under the floor or into a drain. Piped water will flow uphill into a sink because it is being pushed out of the tank by compressed air.